heavy duty rubber cable 0,6/1 kV

Logo Image Logo Image
Technical data
  • Rubber sheath cable to
    DIN VDE 0250 part 812
  • Temperature range
    flexing -25°C to +80°C
    fixed installation -40°C to +80°C
  • Permissible operating temperature
    at conductor +90°C
  • Nominal voltage U0/U 0,6/1 kV
  • Operating voltage in
    three-phase and one-phase a.c.
    U0/U 0,7/1,2 kV
    Direct current system
    U0/U 0,9/1,8 kV
  • Test voltage 3000 V
  • Insulation resistance
    min. 20 MOhm x km
  • Tensile strength
    statical load: total
    cross section x15 N/mm²
  • Minimum bending radius
    fixed installation 4x cable Ø
    flexing 10x cable Ø
    without forced operation 15x cable Ø
Cable structure
  • Tinned copper conductor, to
    DIN VDE 0295 cl.5, fine wire,
    BS 6360 cl.5, IEC 60228 cl.5
  • Core insulation of rubber (EPR)
    compound type 3GI3 to
    DIN VDE 0207 part 20
  • Core identification to DIN VDE 0293-308
    - up to 5 cores coloured
    - from 6 cores, black with continuous
    white numbering
  • GN-YE conductor, 3 cores and above
  • Cores stranded in layers with
    optimal lay length
  • Inner sheath of rubber
    compound type GM1b to
    DIN VDE 0207 part 21
  • Outer sheath of rubber
    compound type 5GM5 to
    DIN VDE 0207 part 21
  • Sheath colour: yellow
  • Ozone resistance
  • High insulation resistance
  • Resistant against hot penetration
  • Low abrasion
  • High notch resistant
  • The code identification of a single core
    sheathed of an insulated wire is black.
Resistant against
  • oils
  • fats and chemicals
  • Behaviour in fire
    to DIN VDE 0482-332-1-2
    DIN EN 60332-2-1, IEC 60332-1 (equivalent
    DIN VDE 0472 part 804 test method B)
  • Oil resistant to DIN EN 60811-404
  • G = with green-yellow conductor
    x = without green-yellow conductor
  • AWG sizes are approximate equivalent
    values. The actual cross section is in mm².
Are suited as a connecting cable for very high mechanical stress in underground mining and tools for use in industries and outdoor use. They are also used for mining industry, surface mining, stone-pits, on building sites, outdoors as well as indoors. Suitable for fixed installation on plaster in dry, damp and wet areas. A long duration of life is guaranteed under extreme operating conditions. Not suitable for drumming and use in all types of machinery, such as robots, handling units and energy transfer units, where constant mobility is essential. The insulation of a plastic-rubber compound on EPR basis improves the resistance to ozone in order to avoid the formation of cracks due to ozone and insulation damages in switch-boards.
CE = Product conforms with Low-Voltage Directive 2014/35/EU.
Data sheet
Certificate of compliance

Part no.